Continue this process until the last segment is programmed. The data for this segment will now be displayed. The data will be entered and the segment will be incremented by 1. To change the data in the current location, enter the number followed by. The hex equivalent will be shown in parenthesis. The data will be displayed on the bottom line. The top line of the display will show the current location number on the left and the segment number on the right. Follow the instructions below for each type of data. This data will be displayed and entered according to the type of data used (numerical, binary, or character data). The bottom line of the display will show the current data. If the location entered is a valid location, the top line of the LCD screen will display the location number on the left and the segment number on the right. Any location can be accessed by directly entering the desired programming location followed by the pound key. Once the number of the module to be programmed has been entered, the LCD screen will prompt you for a location number. Is the module number of the control and # is So the module you are programming should be the first entry. Tip: All modules connected to the NX control panel are programmed through the keypad. LIGHTS IN PARTITIONING MASTER MODE.ĭISPLAYS IN THE PARTITIONING MASTER MODE. ĬHANGING USER CODES.ĪSSIGNING AUTHORITY LEVEL. SET ELAPSED TIME IN MINUTES SINCE LAST AUTOTEST. ĬUSTOM MESSAGES.ĬUSTOM MESSAGES IN LANGUAGE 2. ĪDJUSTING THE VIEW & BRIGHTNESS OF THE LCD.
0 Comments
Leave a Reply. |